Coiled rope or chain

A coil of rope or chain on its own, at the 3D cursor: hung on a peg, dropped on the floor or laid flat.

A rope coiled on its own, to dress a scene: hung on a nail in a barn, dropped on a ship’s deck, laid flat by a well.

  1. In Object Mode, put the 3D cursor where the coil goes.
  2. Press Coiled Rope (or Coiled Chain) in the Fetter tab.
  3. In the Coil section, pick Hanging, Lying or Flat, then set the Loops, their Size and Loop Width, and Messiness.

Hanging: the loops hang on a peg. The object’s origin is the peg’s axis, against the wall: snap the origin onto a nail or a hook of your scene, and turn the object so its back faces the wall (the loops stand off it along the object’s Y axis). Gather at Peg draws the loops together on the peg so a short hook holds them, in up to three rows there, spreading out lower down. Ends sets how far the two ends of the rope hang out of the coil.

Lying: the same loops dropped on the floor, each lying on the ones under it where it crosses them. Flat: a flat spiral, turn beside turn. Both rest on the object’s origin, which sits on the ground.

Move, turn or scale the coil as you like: changing a setting rebuilds it where it is. The Rope (or Links) and Mesh & UVs settings work as on any wrap; a coil has no padlock or hook. New Seed gives another arrangement of the loops.

Last updated: 2026-11-18

Type to search titles, sections and keywords.