Table

Every setting of the table in Souls Prop Builder, as the panel shows it.

Trestle table: top boards, splayed legs on trestles, a keyed stretcher, optional knee braces. Each board, leg and rail breaks off separately.

Dimensions

SettingWhat it does
LengthLength of the tabletop, in cm, end to end.
WidthWidth of the tabletop, in cm, side to side.
HeightHeight of the table, in cm, from the ground to the top of the tabletop.

Top

SettingWhat it does
Top thicknessThickness of the tabletop boards, in cm.
BoardsNumber of boards side by side across the top (1 to 12), each running the full length and all the same width.
GapSpace between the top boards, in cm.
Edge roundingRadius of the rounding on every edge of every piece, in cm. 0 = sharp edges. The wedge keys round by 0.3 cm at most.
Rounding segmentsFaces in each rounded edge (1 to 8): more is smoother but heavier.

Trestles

SettingWhat it does
Inset from the endsDistance from each end of the top to the middle of its trestle, in cm. Larger moves the trestles toward the middle.
Inset from the sidesHow far the bearers stop short of the sides of the top, in cm. The legs’ outer corners sit flush with the bearer ends, so this also sets how wide the legs stand.
Bearer thicknessThickness of each bearer (the beam under the top that the legs hang from), along the table, in cm.
Bearer heightHeight of each bearer under the top, in cm. The legs start under it.
Leg widthWidth of the legs across the table (in the plane they splay in), in cm.
Leg thicknessThickness of the legs along the table, in cm.
Leg splayThe legs lean outward toward the ground by this angle, in degrees (0 = straight). Their top and bottom stay cut flat.
Foot rail above groundHeight of the underside of each foot rail (the bar joining the two legs of a trestle), in cm.
Foot rail heightHeight of the foot rails, in cm.
Foot rail thicknessThickness of the foot rails along the table, in cm.
Knee bracesOne angled brace per leg, from the leg up to the underside of the top, leaning toward the middle of the table.
Brace runHow far each brace reaches along the underside of the top, in cm.
Brace dropHow far below the top each brace meets its leg, in cm.
Brace sizeSide of the square braces, in cm.

Stretcher

SettingWhat it does
Stretcher positionThrough the foot rails: a low stretcher through a hole in each foot rail. Under the top: it runs through the bearers, just under the tabletop.
Stretcher widthWidth of the stretcher across the table, in cm.
Stretcher heightHeight of the stretcher, in cm.
Tenon out of the railsHow far each end of the stretcher sticks out beyond the foot rail or bearer it goes through, in cm.
Wedge keysA small vertical wedge through each tenon, standing just outside the rail or bearer, as if it locked the joint.

Last updated: 2026-11-09

Type to search titles, sections and keywords.