Turns

Rings or spiral, turns, spread, spacing, height and lean.

Lengths are shown in the scene units. Defaults are for a scene in meters.

SettingDefaultWhat it does
Rings / SpiralRingsRings: one closed loop per turn, each closing seamlessly. Spiral: one continuous chain winding around the object, with two free ends.
Turns3How many times the wrap goes around the object.
SpreadFill Selection on separate edges or faces, Centered otherwiseFill Selection spreads the turns evenly where every selected edge or part is: along the shorter of two posts. A spiral of one turn is one loop in the middle of the selection, its two ends side by side. Centered puts them around the middle of the selection, Spacing apart. Forward and Backward start at the selected loop and go one way; around edges or faces, up or down the object.
Spacing15 cmDistance between two turns along the object. Never less than the chain or rope is wide (rings crossing in an X excepted): the status says when it was raised. Hidden while Fill Selection spreads the turns for you.
Height0Moves the wrap up or down the object, along the axis it goes around. With Fill Selection, the turns stay on the selection: up lifts the lowest turn and closes the others up under the top one, down does the opposite. With the other spreads every turn moves.
Lean0°Leans the whole wrap to one side. Not on separate edges or faces.

An open edge path has no turns: the wrap follows the path.

Last updated: 2026-11-18

Type to search titles, sections and keywords.