Souls Destruction Framework compatibility
The compatibility pass that makes every prop break piece by piece with the Souls Destruction Framework.
Souls Prop Builder is the Blender companion of Souls Destruction Framework, GreyFox Studio’s destruction framework for Unreal Engine 5.7 and 5.8, available on Fab. Every prop leaves Blender ready for it: one closed piece per board, stave, plank or bar, real sockets with 0.5 mm of play where pieces fit into each other, small hardware fused into what it holds - so it breaks piece by piece in Souls Destruction Framework with nothing to clean up.
Souls Destruction Framework breaks a prop along its geometry islands: one island, one body. After every build, and again at export, a compatibility pass makes sure that:
- every piece is a closed volume;
- no two pieces share space: where a tenon, a rail end, a strap or a bar end sits inside another piece, that piece is hollowed around it with 0.5 mm of play - a real mortise, invisible on the prop;
- no two pieces come within 0.5 mm of each other, so SDF never welds them back together;
- small hardware (rivets, rings, nail heads under 15 cm3) is fused into the piece it sits on instead of flying off alone;
- the strands of a rope are one body.
The status line ends with SDF-ready when nothing is left to resolve. For presets that wrap each piece in a box, curved or leaning pieces fill only part of their box; a convex-hull preset suits them better.
Last updated: 2026-11-09