Ceramic pot

Every setting of the ceramic pot in Souls Prop Builder, as the panel shows it.

Amphora, jar or vase thrown on the wheel: one closed shell fractured in Unreal, or already cut into shards that each break off on their own.

Dimensions

SettingWhat it does
ShapePicks the profile: Amphora (tall, narrow neck, ear handles), Jar (round, short wide neck, loop handles) or Vase (wide shoulder, flared lip, grooves). Loads that shape’s measurements into the settings.
HeightFrom the foot on the ground to the top of the lip, in cm. The whole profile stretches to fit.
DiameterAcross the widest part of the body, in cm; the handles are not counted. The whole profile scales out to match.

Body

SettingWhat it does
Neck widthScales everything above the shoulder: above 1 the neck and lip open wider, below 1 they close in. The change blends in smoothly from the shoulder up.
WallThickness of the clay wall, in cm (at most an eighth of the diameter). Thicker makes heavier, chunkier shards.
FloorThickness of the bottom, from the underside up to the inside floor, in cm.
LipThickness of the rolled bead at the rim, in cm. The wall swells into it over its last few cm; it is never thinner than the wall.
IrregularityHand-made look, in cm: slow bumps around and along the body and a rim that rises and dips. 0 gives a perfectly wheel-turned pot. Never more than the wall thickness.
SegmentsFaces around the pot. More gives a rounder silhouette and more polygons; fewer gives a lighter, faceted pot.

Handles and decor

SettingWhat it does
HandlesHow many handles, 0 to 4, spread evenly around the pot (two face each other). Each is a strap fused into the wall.
Handle styleEar: from under the lip out and down to the shoulder (amphora). Loop: a ring from the neck to the upper belly (jar).
Handle thicknessThickness of each handle strap, in cm.
Groove bandsBands of lines incised in the outer face, 0 to 3, at the heights the shape sets. Each line is a shallow 2.5 mm cut.
Lines per bandHow many parallel lines in each groove band, 7.5 mm apart.
Chipped lipHow many bites are taken out of the rim and its outer edge, spread around the pot. Each bite is about the lip’s thickness across; the seed moves them.

Breaking

SettingWhat it does
BreakingOne shell: a single closed body that SDF or Chaos fractures in Unreal. Shards: the pot is already cut into pieces 0.6 mm apart, each its own SDF piece.
ShardsHow many shards the pot is cut into (4 to 80), as cells spread over its outer face. Slivers too small to matter are dropped.

Last updated: 2026-11-09

Type to search titles, sections and keywords.