Picking the edges

The four ways to tell Fetter Pro what to wrap: separate edges, faces, an edge loop or an open path.

Fetter Pro reads what is selected in Edit Mode and wraps around it in one of four ways. A line above the buttons says which, before you press them.

SelectionWhat Fetter Pro doesTypical use
Separate edges along the objectThe wrap goes around them and nothing else; Fill Selection spreads the turns where every edge isThe 4 long corner edges of a crate, a coffin or a chest
Faces, in Face Select modeThe wrap goes around the selected faces and nothing else; Fill Selection spreads the turns where every selected part stands. Several parts: Chain on Each Part wraps each one on its ownThree posts lashed together under the boards they hold, the leg of a table
One edge loop around the objectThe turns go around the loopA barrel, a pillar, a statue
An open edge pathThe chain or rope follows the pathA chain laid along a beam or a railing

Tips:

  • Press 2 for edges, 3 for faces. Use Shift+Click to add edges and Alt+Click to select a whole loop.
  • Pick the longest edges you can: the turns spread over their length.
  • A prop built from separate parts (planks, a lid) has no loop around it: select the long corner edges, or the faces of the parts, instead.
  • For faces, press 3 in Edit Mode, then L over a part to pick all its faces. Whole parts selected in Vertex or Edge mode are wrapped the same way.
  • Around edges or faces, the wrap holds on to the selection only: select every outer edge, or every part, it must go over.
  • A mesh with a Mirror modifier shows only half of a loop in Edit Mode: Fetter Pro closes it with its mirror image.

Last updated: 2026-11-18

Type to search titles, sections and keywords.