Pillory
Every setting of the pillory in Souls Prop Builder, as the panel shows it.
Wooden stocks: two posts on sled feet, a rail, two hinged boards with head and hand holes. Every piece is its own SDF body.
Dimensions
| Setting | What it does |
|---|---|
| Width | Distance between the centres of the two posts, in cm. The boards grow with it. |
| Height | Height of the posts from the ground to the top of their forks, in cm. |
Frame
| Setting | What it does |
|---|---|
| Post size | Side of the square post shaft, in cm. Above it the post flares at 45 degrees into the wider forked head. |
| Head depth | Front-to-back depth of the forked head that holds the boards, in cm. The slot fits the boards; what is left on each side are the fork’s cheeks. |
| Head rounding | Radius rounding the outer top edge of each fork cheek, in cm. 0 leaves them square. |
| Foot length | Front-to-back length of each sled foot under a post, in cm. |
| Foot height | Height of each sled foot, in cm. |
| Foot width | How wide each foot is across the pillory, in cm. The post sits in a notch open toward the middle. |
| Foot wall | Wood left between the post and the outer end of the foot’s notch, in cm. |
| Foot end rounding | Radius rounding the top of both ends of each foot, in cm. 0 leaves square ends. |
| Lower rail | Adds a flat plank low between the posts; its widened ends run through the posts and show on both faces. |
| Rail height | Vertical thickness of the rail plank, in cm. |
| Rail above ground | Height of the rail’s underside above the ground, in cm. |
| Rail end depth | Front-to-back depth of the rail’s widened ends, the part inside the posts, in cm. |
| Rail middle depth | Front-to-back depth of the rail between the posts, in cm; never more than the ends. Lower makes a stronger taper. |
| Edge rounding | Rounds every sharp edge of every wooden piece by this radius, in cm. 0 keeps them sharp; it never eats the thinnest wood. |
| Rounding segments | Faces across each rounded edge. More gives smoother rounds and more polygons. |
Boards and holes
| Setting | What it does |
|---|---|
| Board height | Height of each of the two boards, in cm. Together they make the clamp; the holes are cut half in each. |
| Board thickness | Front-to-back thickness of the boards, in cm. The fork slot is cut to fit them. |
| Overhang | How far the boards run past the outside of each post, in cm. |
| Boards above posts | How far the top of the upper board rises above the post tops, in cm. Negative sinks the boards below them. |
| Head hole width | Width of the neck hole in the middle, in cm. |
| Head hole depth | How deep the arc is cut into each board, in cm. Half the width gives a full round hole; less gives a flatter oval. |
| Hand hole width | Width of each wrist hole, in cm. |
| Hand hole depth | How deep each wrist arc is cut into each board, in cm. Half the width gives a round hole. |
| Hand spacing | Distance from the centre of the head hole to the centre of each hand hole, in cm. |
| Hinge and hasp | Adds the iron: hinge plates and a pin at one end, a riveted hasp, an eye and a ring at the other. |
| Hinge side | Which end of the boards carries the hinge; the hasp goes on the other end. |
| Open angle | Swings the top board around the hinge pin, in degrees, when it is built. The top board is its own child object, so you can also rotate it later. |
Last updated: 2026-11-09