Drawing a wrap

Drag a line across the object and the chain or rope goes around it there, with no Edit Mode and no edge to select.

The quickest way, with no Edit Mode and no edge to select. It works on any mesh, even a decimated one with no clean edge loop.

  1. Select the object and press Draw Chain or Draw Rope in the Fetter tab.
  2. Drag a line across the object in the viewport, where the wrap goes. You can turn the view first. Esc or right click cancels.
  3. The wrap goes around the object there. Set Turns and Spacing, and adjust the position with Height and Lean.

A level line gives a level wrap, even seen from above: the wrap stands square to the length of the object, and leans only as far as your line does. A line drawn along the length of the object gives a wrap around that length.

The wrap goes around the parts your line crosses, and the parts touching them (the planks of a coffin), not around another part of the mesh standing apart.

To tie a second object in, like a skeleton to a tree, open Tie Another Object, press Pick the Object to Tie and click the object: the wrap goes around both.

Last updated: 2026-11-18

Type to search titles, sections and keywords.