Limits

What Fetter Pro does not do: hollows, separate parts, knots around an object, physics.

Scope limitation

Know these before you wrap.

  • The padlocks and the eye hook are models: their shackle or eye is made thinner where a tight chain leaves it little room in the link, and on a chain lying on a surface the padlock rests tilted over the links around it. Make LODs keeps them whole (under 1,500 triangles each).
  • A turn is pulled tight round the part of the mesh under it (Follow Shape): it bridges hollows in that slice instead of following the surface into them.
  • An open edge path rests on the convex hull of the whole object: Follow Shape applies to rings and spirals.
  • Only the target object and the tied object are used as the collision shape. Separate lids or parts are not taken into account: join them first or wrap each part.
  • A wrap around selected edges or faces goes around them only: a part in its way that is not selected (a brace, a board) is gone through, not over. Move the turns off it with Height.
  • A separate edge brings in the bar or post it runs along, all round, when that bar is made of quads (the ring of faces around the edge). On triangles, or where the faces around the edge do not close into a ring, only the edge itself counts: select the edges all around, or the faces.
  • A coil is shaped, not simulated: its loops do not rest on the objects around it. Snap its origin onto a nail or a hook, and set it on a floor at its origin.
  • A wrap around edges or faces follows edits of the target while its vertex count stays the same. After adding or deleting vertices, make the wrap again.
  • Separate edges picked before 1.7.0 keep their wrap around the whole object; make the wrap again to have it go around the edges only.
  • A tied object is held by a taut turn around the outline of both objects: the turn does not pass under an arm or make a knot, and one object can be tied per wrap.
  • Slack makes rings hang below what they go round; a ring around an upright post keeps its place (it would only slide down). It is not a physics simulation.
  • A chain hanging between two objects, or laid on a curve, does not rest on or avoid the objects around it: shape the curve, or set the Sag, so it clears them. The hang is a parabola, very close to a real chain’s curve for a prop.
  • A Mirror modifier is followed for an edge loop cut in half by its plane; with a mirror object, or for separate edges and faces, apply the modifier first.
  • Hooks need free ends: use a spiral, an open path, a curve or a hanging chain. Closed rings have no end.
  • The card stops listening to the mouse when the pointer leaves it, so Blender’s autosave keeps running; it takes back the mouse a tenth of a second after the pointer comes back.

Last updated: 2026-11-18

Type to search titles, sections and keywords.