Fit to Surface
Tighten, surface gap, follow shape, slack and going over other wraps.
Lengths are shown in the scene units. Defaults are for a scene in meters.
| Setting | Default | What it does |
|---|---|---|
| Tighten | 1 | Closes the wrap in on the surface. At 1 every link rests on it, rolled on its edge at 45 degrees, and a rope lies against it. At 0 links alternate flat and standing, the flat ones held up in the air. Below 0 the wrap is pushed away, up to its own width. |
| Surface Gap | 0.5 mm | Extra room kept between the wrap and the surface. Raise it if the wrap must clear small bumps such as nails or bolts. |
| Follow Shape | On | The wrap goes round the part of the mesh under it: a chain on a shaft stays on the shaft, even between a wide base and a wide head, and what is not joined to the selected loop is left out. Off: it rests on the convex hull of the whole object, or of the whole selection. |
| Slack | 0 | Rings only. Lets the rings hang loose: they grow longer and sag under their own weight below a beam or a log they go round. A ring around an upright post keeps its place. |
| Go Over Other Wraps | On | Wraps built later on the same object lift over the earlier ones where they cross, instead of passing through them. A hidden wrap does not count: after showing it again, press Rebuild on the wraps above it. |
Last updated: 2026-11-18