Troubleshooting
Fixes for the usual Fetter Pro problems.
| Problem | Fix |
|---|---|
| The Fetter tab shows classic panels instead of the card | Turn on Region Overlap (Edit > Preferences > Interface > Editors), and check that Classic Panels is off in the add-on preferences. |
| Wrap with Chain shows an orange message | It says what is wrong with the selection: read the line above the buttons, which says what the selection gives. Press 2 for edges or 3 for faces. |
| The status line is orange, Not built | The wrap could not be built with these settings; the message says what to change. The mesh shown is the last one built. |
| The status says Too heavy | Lower Turns or Triangles per Link, make the links longer, or raise Twist Length and Rope Radius on a rope. |
| The status says Spacing raised | The turns were closer than the chain or rope is wide: they would cut each other. Lower the turns, or use a thinner chain. |
| The wrap goes around the whole object, not the posts I picked | Separate edges picked before 1.7.0 do: make the wrap again, or pick the faces of the posts in Face Select mode. |
| The wrap cuts through a corner of a post | A post made of quads is taken in whole from one of its edges. On triangles the wrap holds on to the selected edges only: select the outer edges all around, or the faces of the post. |
| The loops of a hanging coil spread too far along my hook | Raise Gather at Peg (1 draws them closest), or lower Loops. |
| Draw Chain says the line does not cross the object | Drag the line over the selected object. Fetter Pro keeps waiting for a line: draw it again, or press Esc. |
| The wrap passes through an object next to it | Tie that object in: open Tie Another Object and pick it. |
| Chain on Curve does nothing when I click | Click on the curve’s line itself, within a few pixels, in Object Mode. The pipette stays on until it finds a curve, or until Esc. |
| A chain on a curve passes through a wall | It follows the curve exactly: move the curve’s points away from the wall. |
| The wrap floats off the object | Another wrap on the same object, made earlier, lies under it (Go Over Other Wraps). Hide or delete that wrap and press Rebuild, or turn Go Over Other Wraps off. |
| The status says the object was deleted | Undo to bring the object back, or press Finalize… to keep the wrap as a plain mesh. |
| The turns do not use the spacing I set | Spread is on Fill Selection: pick Centered to set the spacing yourself. |
| Lay Angle is greyed out | Tighten is at 1, which rolls every link to 45 degrees: lower it to set the Lay Angle. |
| New Seed changes nothing | Every jitter is at 0: raise Offset, Tilt or Roll Jitter, or use the Random tilt pattern. |
| The chain is too heavy for a game prop | Press Presets… > Game Low Poly, lower Triangles per Link, or make the links bigger. |
| No hooks appear | Hooks go on free ends: switch to Spiral, wrap an open path, or hang the chain. |
Last updated: 2026-11-18