Barricade

Every setting of the barricade in Souls Prop Builder, as the panel shows it.

Two broken log posts, nailed planks, a diagonal batten and sharpened stakes. Each plank, post, stake and the batten break off on their own.

Dimensions

SettingWhat it does
WidthDistance between the two posts’ centres, in cm. Never less than the post thickness plus 20 cm.
HeightHeight of the posts, in cm (each varies by a few cm). Raised if needed so the posts rise at least 18 cm past the top plank.

Damage

SettingWhat it does
Missing planksPlanks removed, picked at random. The bottom plank (holding the stakes or the batten) and the top one (holding the batten) are never picked.
Broken planksPlanks snapped off: the part kept stays nailed on one post, its broken end in splinters. Same exceptions as the missing planks.
Missing stakesStakes removed, picked at random.
Kept lengthShare of its length a broken plank keeps (0.2 to 0.9). It always still reaches past its post.

Posts

SettingWhat it does
Post thicknessDiameter of the two rough log posts, in cm. Their fronts are adzed flat where the planks are nailed.
Broken topsOn: the top of each post is snapped off into splinters. Off: the posts are sawn off askew.

Planks

SettingWhat it does
PlanksNumber of planks nailed across the posts, stacked up from the bottom plank. Each plank is its own SDF piece.
Plank heightHeight of each plank, in cm, before the height variation.
Height variationHow much each plank’s height varies at random, as a share (0.15 = up to 15 % taller or shorter). Each plank also leans a little inside its row.
Plank thicknessFront-to-back thickness of the planks, in cm.
GapSpace between two planks, in cm.
Bottom plank heightHeight of the bottom plank’s lower edge above the ground, in cm. The stakes and the batten’s foot are nailed to this plank.
OverhangHow far the planks run past the posts’ outer faces, in cm. Each end gets its own random 25 to 125 % of it.
Broken endsShare of plank ends snapped into splinters instead of sawn (0 = none, 1 = all). Higher also makes the breaks deeper, 6 to 18 cm.
RoughnessHand-hewn wood on planks, batten and stakes: 0 = clean sawn boxes, 1 = very rough (uneven chamfers, wandering faces, ends cut askew). The logs also get lumpier.
NailsForged nail heads: one into each post per plank, two in the batten, one in each stake’s top. Each nail belongs to the piece it holds in SDF.

Batten and stakes

SettingWhat it does
Diagonal battenA hewn batten nailed over the planks, from above the left post down to the right one, below the bottom plank.
Batten widthWidth of the diagonal batten, in cm.
Batten thicknessThickness of the diagonal batten, in cm.
StakesSharpened stakes leaning out from the bottom plank to the ground. Fewer are placed when there is no room beside the batten’s foot.
Stake thicknessSide of the stakes’ square section, in cm.
Stake angleAngle of the stakes below the horizontal, in degrees (each varies by up to 4). Lower = they lean further out.

Last updated: 2026-11-09

Type to search titles, sections and keywords.